WD

 

Purpose:  Used to specify web depth or set its limits for design generation. 

 

-->    Given in girder design input

 

Web depth between flanges (vertical projection for box girders with inclined webs), (Default limits: 0.48L-1.2L inches, where L is the span length in feet, or 40L-100L mm where L is the span length in meters).  Web depth can be specified (USE WD), or limits can be adjusted (UPPER LIMIT WD, LOWER LIMIT WD) using a single value, or a list of values to vary by web section.  With web haunches (see HAUNV , HAUNH , PARABOLIC HAUNCH , LINEAR HAUNCH ) WD is the maximum web depth of each web section. 

 

 

Related topics:

Web Depth Settings

Design Generation Settings Input Reference